井下短周期地震计方位角预处理参数

Preprocessing Parameters of Azimuth Angle for Borehole Short-Period Seismometers

ES评分 0

DOI 10.14075/j.jgg.2025.03.068
刊名
Journal of Geodesy and Geodynamics
年,卷(期) 2026, 46(2)
作者
作者单位

1 中国地震局地震预测研究所地震预测与风险评估应急管理部重点实验室, 北京, 100036;
2 北京港震科技股份有限公司, 北京, 102628;
3 吉林省地震局延边地震监测中心站, 延吉, 133003

摘要
海洋脉动波峰的频带处于井下短周期地震计速度平坦响应范围之外。本文运用传递函数, 恢复低噪声短周期地震计记录的海洋脉动波峰, 并将其作为计算井下短周期地震计安装方位角的信号源。为探究预处理参数对井下短周期地震计安装方位角计算结果合格率的影响, 首先采用6组不同带宽的滤波器, 对24 h连续数据进行预处理滤波; 接着将连续数据划分为5种不同时间长度; 随后运用相关方法计算井下短周期地震计的安装方位角; 最后筛选出东西(EW)和南北(NS)方向平均相关系数大于0.995, 且二者夹角不超过1.2°的安装方位角。结果显示, 采用带宽为0.2~0.6 Hz的滤波器, 对时长300 s的数据进行预处理滤波, 再通过相关计算得到的安装方位角, 其合格次数最多; 并且合格次数在19:00—06:00期间明显多于在07:00—16:00期间。对比地表和井下短周期地震计安装方位角校正前后的地球背景噪声可知, 校正前EW和NS方向并不重合, 校正后二者完全重合, 这验证了使用0.2~0.6 Hz的滤波器和时长300 s的这组预处理参数进行方位角计算的有效性。该预处理参数还可应用于井下甚宽带地震计的方位角校正计算及地表地震计之间对齐误差的测试。
Abstract
The frequency band of oceanic microseismic peaks lies outside the velocity flat response range of borehole short-period seismometers. This study employs a transfer function to restore the oceanic microseismic peaks recorded by low-noise short-period seismometers and uses these restored peaks as the signal source for calculating the installation azimuth angles of borehole short-period seismometers. To investigate the impact of preprocessing parameters on the qualification rate of the calculated installation azimuth angles of downhole short-period seismometers, six sets of filters with different bandwidths were first applied to preprocess 24 hours of continuous data. The continuous data were then divided into five different time lengths. Subsequently, the installation azimuth angles of the borehole short-period seismometers were calculated using a correlation method. Finally, the installation azimuth angles with an average correlation coefficient greater than 0.995 for both the east-west (EW) and north-south (NS) components, and with an angle between the EW and NS components not exceeding 1.2°, were selected. The results show that the most qualified azimuth angles were obtained when the data were preprocessed with a filter bandwidth of 0.2 to 0.6 Hz and a duration of 300 s. Moreover, the number of qualified azimuth angles was significantly higher during the period of 19:00 to 06:00 than during 07:00 to 16:00. A comparison of the Earth's background noise before and after the correction of the installation azimuth angles of surface and borehole short-period seismometers revealed that the EW and NS components did not coincide before correction but were perfectly aligned after correction, thereby validating the effectiveness of using a filter bandwidth of 0.2 to 0.6 Hz and a duration of 300 s for azimuth angle calculation. This set of preprocessing parameters can also be applied to the azimuth correction calculation of borehole very broadband seismometers and the alignment error testing of surface seismometers.
关键词
井下观测; 短周期地震计; 方位角; 预处理参数
KeyWord
borehole observation; short period seismometer; azimuth; pre-processing parameter
基金项目
页码 178-183
  • 参考文献
  • 相关文献
  • 引用本文

刘明辉, 李江, 施鸿昊, 周银兴, 康璐璐, 吴卫远, 韩腾. 井下短周期地震计方位角预处理参数 [J]. 大地测量与地球动力学. 2026; 46; (2). 178 - 183.

  • 文献评论

相关学者

相关机构